Trap List - Fujitsu PRIMERGY BX900 User Manual

6.4 Trap List

The PRIMERGY 10GbE Connection Blade 18/8 supports the following SNMP traps.
- coldStart
is sent when booting up
- linkDown
is sent occurring link-down
- linkup
is sent occuriing lin-up
- authenticationFailure
is sent when failing SNMP authentication
- newRoot
is sent when becoming root bridge
- topologyChange
is sent when occurring STP topology change
- lldpRemTablesChange
is sent when changing adjacent device information management table.
- risingAlarm
is sent when exceeding the uppder threshold of alarm entry
- fallingAlarm
is sent when falling below the lower threshold of alarm entry
- lldpXdcbxMiscControlError
is sent when occurring error except lldpXdcbxDupControlTlv in control sub TLV
-lldpXdcbxMiscFeatureError
is sent when occurring error except lldpXdcbxDupFeatureTlv and lldpdcbxPeerNoFeat in
Feature sub TLV.
-lldpXdcbxMultiplePeers
is sent when detecting multiple peers
-lldpXdcbxLldpTxDisabled
is sent when disabling LLDP Tx
-lldpXdcbxLldpRxDisabled
is sent when disabling LLDP Rx
-lldpXdcbxDupControlTlv
is sent when there are more than 2 control sub TLVs
-lldpXdcbxDupFeatureTlv
is sent when there are more than 2 feature sub TLVs
-lldpXdcbxPeerNoFeat
is sent when the peer doesn't support the feature
-lldpXdcbxPeerNoResp
is sent when detecting LLDP response time-out
-lldpXdcbxPeerConfigMismatch
is sent when there are configuration mismatch with the peer
PRIMERGY 10GbE Connection Blade 18/8 User Guide
95 / 95