Fujitsu PRIMERGY BX900 User Manual page 53

PRIMERGY 10GbE Connection Blade 18/8 User Guide
This section describes how to configure for SNMPv3 access
<Configuration target>
Use SNMP agent function
Administrator suzuki
System name SBAX2
Location 1F
Agent address:192.168.1.1
SNMP host address:192.168.1.100
Host address for trap: 192.168.1.100
User name:user00
Authentication protocol:MD5
Password : auth_password
Encryption Protocol : DES
Password: priv_password
MIB view: Only system and interfaces groups are enabled
Only linkDown and linkUp traps are enabled.
<Commands>
Configure SNMP agent infomration
(config)#snmp agent contact suzuki
(config)#snmp agent sysname SBAX2
(config)#snmp agent location 1F
(config)#snmp agent adress 192.168.1.1
Configure SNMPv3 Information
(config)#snmp user 0 name user00
(config)#snmp user 0 address 0 192.168.1.100
(config)#snmp user 0 notification 0 192.168.1.100
Configure Authentication/Encryption protocol
(config)#snmp user 0 auth md5 auth_password
(config)#snmp user 0 priv des priv_password
Configure MIB view information
(config)#snmp user 0 read view 0
(config)#snmp user 0 notify view 0
(config)#snmp view 0 subtree 0 include system
(config)#snmp view 0 subtree 1 include interfaces
(config)#snmp view 0 subtree 2 include linkdown
(config)#snmp view 0 subtree 3 include linkup
Enable SNMP Agent function
(config)#snmp service on
Savte the configuration
(config)#save
52 / 95