Reset Switch (F); Hardware Specifications - Fujitsu PRIMERGY BX900 User Manual

1.1.4 Reset Switch (F)

The PRIMERGY 10GbE Connection Blade 18/8 has a reset switch to restart this Connection Blade (hard
reset) and to boot up backup firmware.
Hard Reset:
Push the reset Switch and then release it soon.
Boot up Backup Firmware:
Push the reset switch until port LEDs start blinking green (about 5sec to 10sec) and then release it.
Note
You can enter the backup firm by pressing Ctrl-B while "Booting ..." message is displayed.

1.1.5 Hardware Specifications

Table 3 shows the hardware specifications of the PRIMERGY 10GbE Connection Blade 18/8.
Interface
ETHER(LAN)port
Standard
Downlink port（port1-18） 18 ports（10GBASE-KR）
Uplink port（port19-26）
Management blade
connection port
(oob）
Console Port
Standard
#of ports
Data transfer rate
Connection mode
Operating Voltage
Power Consumption
External dimensions（H x D x W）
Weight
Ambient Requirements
Item
Table3. Hardware Specifications
PRIMERGY 10GbE Connection Blade 18/8 User Guide
Specifications
IEEE 802.3
8ports（10GBASE-LR/SR/CR (SFP+)）
1port
(10/100Base-T,Ethernet connection
via management blade)
RS-232C
1
9600bps
Serial connection via management blade
DC +12 V
Max 36W
29 x 268 x 193 (mm)
1.5 kg
[Temperature]
On operation:5 ~35 degrees C
7 / 95