Service Tools Required; Adding A Hot-Plug Sas Disk Drive - HP Integrity BL860c User's & Service Manual

Service Tools Required

Service of this product can require the following tools:
An IPF Processor Install Tool Kit, consisting of:
Disposable ESD Kit
Processor installation tool (2.5 mm hex and Torx 15 screwdriver)
NOTE:
included with the processor.
The server blade has a Torx T–15 screwdriver mounted on the inside of the access panel.

Adding a Hot-Plug SAS Disk Drive

Use the following procedures if the server blade has a disk drive blank installed and you need to
install a hot-plug SAS disk drive.
For a list of supported SAS disk drives for the server blade, see:
products/blades/components/c-class-storage.html
1. Press the release buttons simultaneously. See
2. Pull the blank out of the drive bay.
Figure 9 Removing a Disk Drive Blank
CAUTION:
blank. Operating the server blade without a SAS disk drive or disk drive blank causes improper
airflow and cooling that can lead to thermal damage to the server blade.
To install a SAS disk drive:
1. Slide the drive into the cage until it is fully seated (1).
See Figure
28 Installing the Server Blade Into the Enclosure
If you purchased an additional processor, the IPF Processor Install Toolkit is
Always populate hard drive bays with either a SAS disk drive or a disk drive
10.
http://h18004.www1.hp.com/
Figure 9.