Removing And Replacing The Server Blade Access Panel; Removing The Server Blade Access Panel; Replacing The Server Blade Access Panel - HP Integrity BL860c User's & Service Manual

1. Slide the server blade back into the enclosure until flush with the enclosure.
2. Close the lever.
NOTE:
to standby power (Internal health LED is amber), or full power (internal health LED is green,
and the fans may get louder).
3. If the server blade does not come up to full power, push the Power button to get the server to
full power.
The fans might get louder as the server powers up to full power.

Removing and Replacing the Server Blade Access Panel

The access panel is located on the right side of the server blade (when mounted in an enclosure).

Removing the Server Blade Access Panel

To remove the access panel:
1. Power off the server blade and remove it from the server blade enclosure.
See "Preparing the Server Blade for Servicing" (page
2. Unlock the cam on the access panel latch (if necessary) by turning the lock on the latch
counterclockwise with a 2.5 mm allen wrench.
3. Pull up on the access panel latch (1).
This causes the access panel to slide back about 1.75 cm (0.75
4. Remove the access panel by lifting it straight up and off the server blade (2).
Figure 38 Removing the Server Blade Access Panel

Replacing the Server Blade Access Panel

To replace the access panel:
1 12 Removing and Replacing Components
After you install the server blade back into the enclosure, the server blade might go
110).
in).Figure 38.