Raid Properties Screens - HP Integrity BL860c User's & Service Manual

PCI Address
FW Revision
SAS Address
FW Revision
Status
Boot Support

RAID Properties Screens

There are four screens within RAID properties. To access the screens, select RAID Properties from
the Adapter Properties screen. The Select New Array Type screen displays. See
56 Installing the Server Blade Into the Enclosure
Displays the PCI Address assigned by the system BIOS to the adapter.
Bus value range 0x00 - 0xFF, 0 - 255 decimal
Device value range 0x00 - 0x1F, 0 - 31 decimal
Function range 0x00 - 0x7, 0 - 7 decimal
Displays the MPT firmware version and type. The format is x.xx.xx.xx-yy
where:
x.xx.xx.xx refers to the FW version
yy refers to the type.
The currently supported type is IR.l).
Displays the SAS Address assigned to this adapter.
Displays the Fusion MPT firmware version and type (IR or IT)
Indicates whether an adapter is eligible for configuration utility software control
or is reserved for control by other software (Enabled, Disabled or Error).
Enabled Indicates the EFI Driver is controlling the adapter or will attempt
to control the adapter upon reload.
Disabled Indicates the EFI Driver is not controlling the adapter or will
discontinue control of the adapter upon reload.
Error Indicates the EFI Driver encountered a problem with the adapter.
Viewing and modifying settings for the adapter is allowed but
the information and functionality available may be limited.
Specifies whether an adapter is eligible for configuration utility software control
or is reserved for control by other software (Enabled BIOS & OS, Enabled
BIOS Only, Enabled OS Only, or Disabled).
Enabled BIOS & OS – SAS controller is controlled by the BIOS and OS
driver.
Enabled BIOS Only – SAS controller is controlled by the BIOS. This setting
may not be supported by all OS drivers. For example, it is not possible
to disable an adapter in a Windows driver.
Enabled OS Only – SAS controller is controlled by the OS driver.
Disabled – SAS controller is not controlled by the BIOS when the SAS
controller is loaded. However, the adapter is visible through the
configuration protocol.
Changes to the Boot Support setting are reflected in the Status field of the
Adapter List menu. The new settings do not take effect until the BIOS is reloaded
(system reboot).
Figure 30 (page 57).