HP Integrity BL860c User's & Service Manual page 145

IMPORTANT: Make sure the front display panel connector fully seats into the system board
connector. If the connector is not fully seated, the server blade can have intermittent failures.
See Figure 82.
Figure 82 System Board / Front Panel Connection
In Figure 1–Bad connection, the connector is not properly seated. In Figure 2–Good connection,
the connector is properly seated.
6. Install the TPM.
See "Replacing the TPM" (page
7. Install the air baffles.
See Figure 79 (page
8. Install the mezzanine card or cards.
See "Replacing a Mezzanine Card" (page
9. Install the SAS backplane.
See "Installing the SAS Backplane" (page
10. Install the memory DIMMs.
See "Replacing a DIMM" (page
1 1. Install the processors.
See "Installing a Processor" (page
12. Install the hard disk drives.
See "Replacing a SAS Disk Drive" (page
13. Install the access panel.
See "Replacing the Server Blade Access Panel" (page
14. Install the server blade into the enclosure.
See "Replacing the Server Blade in the Enclosure" (page
141).
143).
124).
120).
115).
117).
109).
112).
111).
Removing and Replacing the System Board 145