Lanaddress; Syntax; Parameters; Monarch - HP Integrity BL860c User's & Service Manual

Example 19 ioconfig command
Shell> ioconfig
Deconfigure or reconfigure IO components or settings
IOCONFIG [fast_init | wol [on | off]]
fast_init
mps_optimize Specifies PCIe optimization setting
wol
on | off
Note:
1. If fast_init is enabled, firmware will connect only the minimum set of
devices during boot.
feature if failure occurs.
2. A reboot is required for PCIe MPS optimization changes to take effect
3. Any pending Wake-On-LAN request will not be cleared until reboot if
the setting is changed to disabled.
System will clear pending Wake-On-LAN requests each time the system
reboots if the setting is disabled.
Examples:
* To display the current settings
fs0:\> ioconfig
Fast initialization: Enabled
MPS optimization:
System Wake-On-LAN:
* To display the current device connection policy setting
fs0:\> ioconfig fast_init
Fast initialization: Enabled
* To disable fast initialization
fs0:\> ioconfig fast_init off
Fast initialization: Disabled
* To enable the System Wake-On-LAN setting
fs0:\> ioconfig wol on
System Wake-On-LAN: Enabled

lanaddress

Enables you to display the core I/O MAC address.

Syntax:

lanaddress

Parameters

none
Example 20 lanaddress Command
LAN Address Information:
LAN Address
-----------------
Mac(00306E4C4F1A)
*Mac(00306E4C0FF2)

monarch

Displays or modifies the ID of the bootstrap processor. The preferred monarch number is stored in
NVM.
166 Utilities
Specifies device connection policy setting
Specifies System Wake-On-LAN setting
Specifies to configure or deconfigure a feature or component
This feature might cause boot failure; disable this
Disabled
Disabled
Path
----------------------------------------
Acpi(HWP0002,0)/Pci(3|0)/Mac(00306E4C4F1A))
Acpi(HWP0002,100)/Pci(2|0)/Mac(00306E4C0FF2))