05-4055A01, Rev. E
Figure 3-27. Remote Serial Gateway Menu—Initial Screen
•
RSG Talkback Enable
enabled and the RSG is set up for UDP mode, a message
from a Remote radio (usually a reply to a poll) is sent to the
last IP address or port from which a message was received.
[
Enabled, Disabled; Enabled
•
RSG Talkback Timeout
after which, if no data has been received from the IP host, the
RSG talkback feature expires. When this happens, the RSG
reverts to its configured IP address and port for upstream data
destined for an IP host. [
•
—This selection allows entry of key RSG
RSG Entries
parameters including Unit ID, COM port setting, Mode, and
Local IP Port. This screen is shown in
Page
64.
•
Remote Serial Wizard
changing a configuration to your remote serial gateway
entries. These are the same settings contained in RSG Entries
Screen, but the Remote Serial Wizard presents a step-by-step
series of screens with explanatory text to assist you in making
your selections.
MDS entraNET Technical Manual
Invisible place holder
(UDP IP-to-Serial)—When Talkback is
]
—Use this selection to set a time limit
Time in seconds; 30
Figure 3-28 on
—This tool assists you in adding or
]
63