Log-In And Configuration - GE MDS entraNET 900 Technical Manual

Telnet Connection
Using the AP LAN
Port (a valid IP
address must be set)
22
NOTE: The exact parameters given above must be used for console
terminal communication. Improper settings are a common
cause of difficulty.
To configure the AP using its
1. Connect a PC Ethernet port to the AP with an Ethernet crossover
cable.
NOTE: The radio must first have a valid IP address programmed—the
default IP address is 192.168.1.1.
2. Log in to the AP as follows:
a. Press the
ENTER
LED flashes to indicate data communications.
a. At the prompt, enter the username (
login
username). Press
b. At the
Password
password). Press
Information Screen appears.
3. Review the current menu settings and make any necessary changes.
Refer to Set Key AP Parameters
ance.
4. Repeat Steps 1 through 3 for any other AP radios in your system.
NOTE: You can save time by using configuration scripts to uniformly
configure multiple transceivers. This technique is discussed in
the Configuration Scripts Menu
Set Key AP Parameters
Table 2-1 provides a listing of key AP operating parameters, their
default settings, and their values or range. Typically, these are the only
settings that need to be set or reviewed for a basic check of the radio
system. A complete list of AP commands appears in
MANAGEMENT, beginning on Page
MDS entraNET Technical Manual
port:
LAN
key to receive the
login
.
ENTER
prompt, enter the password (
Upon successful log-in, the Starting
ENTER .
on Page 22 for configuration guid-
on Page 87.
29.
prompt. The /
COM1 LAN
is the default
admin
is the default
admin
CHAPTER 3 AP
05-4055A01, Rev. E