Step-By-Step Instructions For Configuring A Point-To-Point Serial Connection - GE MDS entraNET 900 Technical Manual

124
Figure 5-4. Point-to-Point Serial-to-Serial Application Diagram
Use the Serial Configuration Wizard (Local Serial Configuration menu)
to make the settings listed in the table below. Following the table are
step-by-step screen images of the Wizard.
Table 5-4. Point-to-Point Serial-to-Serial Configuration
MDS entraNET
radio Location
AP (COM2)
Remote radio (COM2)
5.4.1 Step-by-step Instructions for Configuring a
Point-to-Point Serial Connection
1. Connect a powered AP radio to a PC.
2. At the PC, open a connection with the Access Point radio using a
terminal, Telnet, or Web browser session.
3. Press to display the Main Menu.
G
MDS entraNET Technical Manual
Invisible place holder
Menu Item Setting
Port Status Enabled
Mode Serial-to-Serial
Remote UnitID 1155999 (example)
Rem. COM Port COM2
Baud Rate 19200
Byte Format 8N1
Buffer Size 256 Bytes
Inter-Packet Delay 4
Mode Data
Baud 19200
Format 8N1
Buffer 256
DelayChars 4
05-4055A01, Rev. E