GE MDS entraNET 900 Technical Manual page 121

ETH
HANDOFF
05-4055A01, Rev. E
—Displays all settable optional arguments and their current values.
CMD
You can copy this list to a text file as a record of your configuration.
Sets or displays the configuration of the Ethernet port. You can set the
port to a specific Ethernet address (static mode), or the address can be
determined automatically based on the first received packet (autoselect
mode).
Optional arguments:
ENDPT=<string of bytes in hex that is the endpoint MAC address>
displays the Ethernet endpoint address, and sets the endpoint address
behavior. The Ethernet address must be in the following format:
.
xx:xx:xx:xx:xx:xx
Set to the device's Ethernet address, or set the address to a
ETH ENDPT
string of zeros to use the address of the source of the first received
packet.
ENDPTMODE=<auto, static>
—Endpoint address is automatically set to the source
AUTO
address of the first received packet.
—Endpoint address is manually configured.
STATIC
—Determines whether the Ethernet port is enabled or
MODE=<ON|OFF>
disabled.
: Ethernet port is enabled.
ON
: Ethernet port is disabled.
OFF
—Displays all settable optional arguments and their current values.
CMD
You can copy this list to a text file as a record of your configuration.
Sets or displays the hand-off configuration.
Optional arguments:
—The percentage of hops for which data transmission
ACKAVG=<percent>
was successful (an ACK for the hop was received). This average is
sampled every hop over an interval as defined by
—
ACKAVGINT=<integer>
ACKs received over 1, 2, 4, 8, 16, 32, 64, or 128 hops.
ACKAVGTHRESH=<percent>
(1–99).
BLOCKTIME=<seconds>
block access to an AP after hand-off.
MDS entraNET Technical Manual
—Displays the endpoint IP address behavior:
averaging interval, defined as averaging
ACKAVG
—The hand-off threshold for ACK averaging
—Sets or displays the time in seconds (0–255) to
—Sets or
HANDOFF ACKAVGINT=
111
.