GE MDS entraNET 900 Technical Manual page 120

ENCRYPT
110
—Sets or displays the network (system) address
NETADDR=<netaddr>
(0-30000) when in direct mode.
PWR=<range integer>—
setting in dBm (the range depends on the radio model).
REPEAT=<range integer>
Broadbase Repeat Count.
: Min=0
0
: Max=15
15
RETRY=<range integer>
Maximum Unicast Retry Count.
: Min=0
0
: Max=15
15
SKIPZONES=<bitmap>
Binary Map (HEX: preceded by
; 1=Skipped 0=Active
bit0:ZONE1
; 1=Skipped 0=Active
bit1:ZONE2
; 1=Skipped 0=Active
bit2:ZONE3
; 1=Skipped 0=Active
bit3:ZONE4
; 1=Skipped 0=Active
bit4:ZONE5
; 1=Skipped 0=Active
bit5:ZONE6
; 1=Skipped 0=Active
bit6:ZONE7
; 1=Skipped 0=Active
bit7:ZONE8
—(read only) Displays the current Direct mode status.
STATE=
Currently operating in Infrastructure mode
Currently operating in Direct mode
—Sets or displays the role of this radio in Direct mode.
TYPE=
: Operates as one of the Node Remotes
NODE
: Operates as the Single Root Remote
ROOT
Sets or displays the configuration for data encryption.
Optional arguments:
—Sets or displays the data encryption mode.
MODE=<ON|OFF>
: Data encryption on
ON
: Data encryption off
OFF
—Sets or displays the Encryption Pass Phrase (8–41
PHRASE=<string>
characters).
MDS entraNET Technical Manual
In mode, this command sets the radio power
ROOT
—In mode, this command sets the
ROOT
—In mode, this command sets the
ROOT
—In mode, this command sets the Skip Zones
ROOT
).
0x
05-4055A01, Rev. E