GE MDS entraNET 900 Technical Manual page 124

RADIO
114
—Bootloader Image
BOOT
—Firmware application image 1
APP1
—Firmware application image 2
APP2
—Tor 1 Image
TOR1
—Tor 2 Image
TOR2
Sets or displays the radio configuration and status.
Optional arguments:
—(read only) Displays the associated AP Serial Number.
AP=
—(read only) Displays whether or not the Remote radio has
ASSOC=
been associated with an AP.
—Displays all settable optional arguments and their current values.
CMD
You can copy this list to a text file as a record of your configuration.
—The current network address (1-15 alphanumeric
NETADDR=<string>
characters).
—Sets or displays the current power setting. The value is in
PWR=<dBm>
dBm, with an acceptable range of 0–30 for 900 MHz radios, 10–20 dBm
for 2.4 GHz ETSI radios, or 17–27 dBm for 2.4 GHz non-ETSI radios.
—(read only) Displays the quality of the over-the-air link,
QUALITY=
expressed as a percent (0-100). Quality is calculated from the successful
reception of ACK packets sent by the AP (0-100).
—Connection refresh period in seconds (0–255). The
REFRESH=<refresh>
Remote inherits the
value to the parameter.
refresh
—(read only) Shows the Received Signal Strength (RSSI). The
RSSI=
value is shown in dBm, with a range of -120 to 0. This value is refreshed
every 3 sec.
—(read only) Shows the current state of radio synchronization.
SYNC=
—Starts or stops the transmitter test.
TX KEY=<on, off>
TX FREQ=<valid frequency range>
(in MHz) for transmitter tests. The valid range is 902.2–927.6 for
900 MHz radios, or 2400.6–2482 for 2.4 GHz radios.
—The 32-bit user-programmable radio address, which
UNIT=<unit>
defaults to the radio serial number, but can be changed.
MDS entraNET Technical Manual
value from the AP and applies that
database timeout
—Sets or displays the carrier frequency
05-4055A01, Rev. E