Remote Management Submenu - GE MDS entraNET 900 Technical Manual

70
•
EndPoint Logging
endpoint logging is enabled or disabled. [
]
Enabled
3.8.1 Remote Management Menu
The Remote Management Menu
particular Remote to manage, based on the radio Unit ID number
(generally the last four digits of its serial number).
Figure 3-33. Remote Management Menu
•
Remote to Manage
(typically a four-digit code).
•
Manage Selected Remote
Figure 3-34 on Page
to set the characteristics of Remote radios in the network.
•
Broadcast Remote Programming
submenu (Figure
new firmware images and Remote restart commands.
NOTE: Before programming a Remote radio over the air, be sure to set
ETHERNET BRIDGING
Page 51) from
BROADCAST/MULTICAST
Otherwise, you might experience sync errors, or programming
might not complete. Excessive broadcast/multicast traffic
from a connected LAN can also cause problems.
MDS entraNET Technical Manual
—This selection is used to specify whether
(Figure 3-33) allows selection of a
—Radio address of the Remote to be managed
—Displays the screen shown in
71, which contains several parameters used
—Selecting this item brings up a
3-36) where you can initiate the broadcast of
(see "Bridge Configuration Menu" on
(default) to either
ALL
.
Enabled, Disabled;
or
DISABLED NO
05-4055A01, Rev. E