Security Configuration - GE MDS entraNET 900 Technical Manual

64
Figure 3-28. Remote Serial Gateway (RSG) Entries Menu
(TCP configuration; UDP is similar)
• —Enter
Unit ID
for unicast (directed) data. The Unit ID defaults to the last
four digits of the radio serial number, but can be set to any
32-bit integer. If set to
targeted.
• —Identifies a group used for serial multicast traffic.
Group Id
When set to a non-zero value, the
parameters are not available because the entry identifies a
Group, and a Group does not use these parameters.
COM Port
zero.
[0-15; 0]
•
COM Port
connection.
• —The type of IP port, or socket, used by the AP for
Mode
encapsulation of serial traffic.
•
Local IP Port
application must connect when exchanging data with the
corresponding remote radio(s).
•
TCP Keepalive
TCP connection can be inactive before it is disconnected. If
the value is set to zero, the port is off. [
NOTE: Although a Group is defined at the AP, the members of the
group are defined at each remote radio.
Menu" on Page 75

3.7 SECURITY CONFIGURATION

The entraNET system contains built-in security features for your
transceivers and the network. These options start with controlling
MDS entraNET Technical Manual
Invisible place holder
, or enter the Unit ID of the Remote
Broadcast
Broadcast
parameters are available when this value is set to
—The remote serial port associated with this IP
—The IP port number at the AP to which the
—This value sets the number of seconds that a
for more information.
, then all remotes are
and
Unit Id COM Port
Unit Id
[TCP Server; UDP]
]
0-600; 5
See "Group Database
05-4055A01, Rev. E
and