Mobility Configuration Menu - GE MDS entraNET 900 Technical Manual

05-4055A01, Rev. E

3.4.4 Mobility Configuration Menu

Figure 3-16. Mobility Configuration Menu
•
BSP Routing Enable
transmission and routing of Basic Serial Protocol
packets.[
Enabled
• —This parameter enables the Inter-Access Point
IAPP Enable
Protocol (IAPP), which allows APs to pass payload data over
the Ethernet LAN. [
•
Unit Update Enable
immediately send out an IAPP update when a Remote connects
or disconnects. [
•
IAPP Multicast Address
messaging to reach all radios in a subnetwork (all radios with a
common network address). [
•
IAPP Multicast Port
multicast messaging to reach all radios in a subnetwork (all
radios with a common network address). [
•
IAPP Multicast TTL
number of hops that a message is allowed to make before it is
no longer transportable. This feature prevents "infinite life"
packets that degrade system performance. [
•
IAPP Unicast Por
a specific radio when that message has originated from another
subnetwork. [
MDS entraNET Technical Manual
Invisible place holder
Invisible place holder
—This parameter controls intra-cell
, ; ]
Disabled Disabled
,
Enabled Disabled
—This parameter allows the AP to
, ;
Enabled Disabled Disabled
—An address that allows multicast
224.254.1.1
—An assigned software port that allows
—Multicast "time to live" number. This is the
t—An address that allows messaging to travel to
]
39990
; ]
Disabled
]
]
]
39990
]
1-15; 1
49