Bridge Configuration Menu - GE MDS entraNET 900 Technical Manual

05-4055A01, Rev. E
•
Auth Trap Enable
[
Disabled/Enabled; Disabled
•
SNMP v3 Password Mode
managed locally or using an SNMP Manager. The different
behaviors of the Agent, depending on the mode selected, are
described in
SNMP Mode
•
Trap Manager (#1–#4)
traps are sent. [

3.4.6 Bridge Configuration Menu

Figure 3-18. Bridge Configuration Menu
•
Ethernet Bridging
the air to Remote radios. [
IP/ARP Only; All
• —This value is used along with the MAC address
Bridge Priority
to define the bridge ID. The Bridge ID is used by the Spanning
Tree protocol to determine the root bridge in the network. This
value is useful for forcing a certain bridge to always be the root.
•
Bridge Hello Time
Bridge Protocol Data Units (BPDU) are sent out by the AP.
Each bridge in the network should have the same hello time.
[
Number of seconds; 2
•
Bridge Forward Delay
the "learning" and "listening" states. Traffic begins forwarding
through the bridge after twice the Forward Delay time. [
]
of seconds; 5
MDS entraNET Technical Manual
—Current state of the authentication traps.
]
—Determines whether v3 passwords are
above. [
Manager, Local; Manager
— Table of up to four locations to which
]
Any valid IP address
Invisible place holder
Invisible place holder
—Select the type of Ethernet frames sent over
All, Disabled, No Broadcast/Multicast,
]
—Defines how often Spanning Tree protocol
]
—This value decides how long a bridge is in
]
Number
51