Redundancy Menu - GE MDS entraNET 900 Technical Manual

05-4055A01, Rev. E

3.12 REDUNDANCY MENU

Redundancy is available only at the AP. The Redundancy Menu
(Figure 3-57) is used in protected installations where a backup
transceiver can be immediately placed online if a primary radio fails.
This protects against "single point of failure" scenarios. The
Redundancy Menu contains selections and settings that are used to
manage redundancy functions.
NOTE: Redundancy functions require the presence of a supervisory
board (GE MDS Part No. 03-6061Axx). Ask your GE MDS
representative for details.
Figure 3-57. Redundancy Menu
•
Redundancy Configuration
disable redundancy operation. When the supervisory board
detects an alarm condition, the currently selected transceiver is
disabled, and the backup transceiver comes online. [
Disabled; Enabled
•
Network Event Triggers
Figure 3-58 on Page
conditions.
MDS entraNET Technical Manual
Invisible place holder
—This selection is used to enable or
]
—This selection presents a submenu (see
94) with Ethernet (network) alarm
Enabled,
93