Commands; Entering Remote Commands; Minimum Configuration For Remotes - GE MDS entraNET 900 Technical Manual

102
2. At the
username
3. At the
Password

4.4 Commands

Table 4-1 on Page 103
commands for the Remote transceiver. Detailed descriptions for these
commands follow in

4.4.1 Entering Remote Commands

To enter a command:
• Type the command (including any spaces), and then press
.
ENTER
To request or set a value:
• Type the command, press
For example:
• Type
COMMAND_ARGUMENT=
• Type
COMMAND_ARGUMENT=VALUE
To get help with a command:
• Type the command, press
4.5

Minimum Configuration for Remotes

Remote radios require little configuration to operate, as most of the
configuration is conducted at the AP. The minimum set of parameters
that needs to be set for a Remote are:
—32-bit radio address. Defaults to the radio serial
RADIO UNIT
number, but is settable.
RADIO NETADDR
address.
—RF output power setting in decibels (dB). The
RADIO PWR
range is 20-30 for non-ETSI 900 MHz radios, 20-27 for
non-ETSI 2400 MHz radios, and 10-20 for ETSI 2400 MHz
radios.
MDS entraNET Technical Manual
prompt, enter your username (
prompt, enter your password (
provides a quick reference to the various
Section 4.5.1.
, and then press
=
to query a setting or value.
, press
SPACE
—Radio network address. Must match the AP
is the default).
admin
is the default).
admin
.
ENTER
to set values.
, and then press
? ENTER
05-4055A01, Rev. E
.