View Current Settings Screen-Unicast Udp Mode Example - GE MDS entraNET 900 Technical Manual

05-4055A01, Rev. E
View Current Settings Screen—Unicast UDP Mode Example
Figure 3-26 shows a sample View Current Settings Screen for a system
configured for Unicast UDP mode. The selections shown are similar to
the serial-to-serial example above, but some items are UDP specific.
Figure 3-26. Serial Configuration Current Settings Screen
The following text explains the key settings for the Serial Configuration
Menu (Unicast UDP example).
• —This selection is used to enable or disable the
Port Status
serial data port for payload data operation. Normally,
is disabled to permit Console Terminal operation.
NOTE: When
COM1
through
COM1
typing the escape sequence
This restores
again.
• —Used to set the method the host uses to connect to the
Mode
radio. [
Serial, Network; Network
• —This selection is used to specify which local IP
RX IP Port
port address should be used to receive data from the host, as
well as the IP address and port number of the host to send
data to at the remote end.
•
TX IP Address
address that will receive data from the host, as well as the IP
MDS entraNET Technical Manual
Invisible place holder
is enabled for data, management of the radio
is disabled. This problem can be remedied by
SHIFT
to console terminal mode. You must log in
COM1
]
—This selection is used to specify the local IP
COM1
+ + + followed by
ENTER
.
61