Set Point During Sp Ramp; Mv Monitor (Heat); Mv Monitor (Cool) - Omron E5AK User Manual

CHAPTER 5 PARAMETERS
Level 0 Mode
Set point during SP
ramp
• Monitors the set point during SP ramp
• Matches the set point of the "PV/SP" parameter when the set point is not during
SP ramp .
Function
Local SP : Local SP setting lower limit to local SP setting upper limit
Remote SP : Remote SP lower limit to remote SP upper limit
Monitor
F Related article
4.2 Operating Condition Restriction/SP ramp (page 4-6)
F Related parameters
See
"PV/SP" (level 0 mode)
"SP ramp time unit" "SP ramp set value" (level 2 mode)
"Set point upper limit" "Set point lower limit" (expansion mode)
"SP mode" (level 2 mode)
"Remote SP enable" "Remote SP upper limit" "Remote SP lower limit" (option
mode)

MV monitor (heat)

MV monitor (cool)

• This parameter cannot be set.
• Monitors the manipulated variable on the heating or cooling side.
• The manipulated variable in a standard control system is checked in the "MV
Function
monitor (heat)" parameter.
• The "MV monitor (cool)" parameter can be used only during heating and cooling
control.
• MV monitor (heat)
Standard
Monitor
Heating and cooling
• MV monitor (cool)
Heating and cooling
E5AK-AA2 AC100-240
E5AK-AA2 AC/DC24
Model
5--8
Monitor Range
Control
Monitor Range
-5.0 to 105.0
0.0 to 105.0
Control
Monitor Range
0.0 to 105.0
Conditions of Use
The remote SP function must be
enabled. When the remote SP function
is disabled, this function can be used
only when the SP ramp function is
enabled.
Conditions of Use
Control must be standard control or heat-
ing and cooling control.
Unit
%
%
Unit
%
Unit
EU
EU