Transition Of Parameter Display - Omron MX2 Series User Manual

Transition of Parameter Display

The following figure shows how to operate the Digital Operator to reach the intended parameter display.
Monitor Mode "d"
Parameter display
Function Mode "F"
Parameter display
Extended Function Mode "A"
Parameter display
Extended Function
Mode "b"
Extended Function
Mode "C"
Extended Function
Mode "H"
Extended Function
Mode "P"
Extended Function
Mode "U"
*2
Monitor Mode "d"
Multi-function Compact Inverter 3G3MX2-V1 User's Manual (I585-E1)
On the parameter display
Moves to Data dis-
*1
play.
On the parame-
ter display
On the parameter display
Stores the data.
Returns to d001.
3 Operation and Test Run
Data display
d001: Output Frequency Monitor
Use the Increment/Decrement key to increase or
decrease the parameter number. Pressing the Incre-
ment key at the end of mode returns to the beginning
of the same mode.
Moves to Data display.
Data display
F001: Output Frequency Setting
On the parameter display (F001 to F*03)
Changes are entered instantaneously, so the value does not blink.
: Stores the value to the EEPROM and returns to
the parameter display.
: Returns to the parameter display, without storing
the value to the EEPROM.
Data display
A001: Frequency Reference Selection
On the parameter display
All digits of the value blink after each change.
While the digits are blinking, the change is not reflected.
: Enters/stores the value and returns to the parameter
display.
: Cancels the change and returns to the parameter display.
In the parameter display or data display mode,
pressing the Increment and Decrement keys
simultaneously enables quick change of the
parameter value.
For details, refer to Individual Input Mode
(Direct Input or Selection) on page 3-10.
*1. Data cannot be changed in the monitor mode "d."
*2. After the extended function mode "U," the display
returns to the monitor mode "d."
3
3 - 7