Removal Of Each Part; Removing Covers - Omron MX2 Series User Manual

2-2

Removal of Each Part

2-2-1

Removing Covers

Before wiring each terminal block, you need to remove the terminal block cover and the backing plate.
This section describes how to remove these covers.
To install a communications option unit, you must remove the option unit cover beforehand.
For how to install an option unit, refer to the user's manual for each option unit.
Removing Terminal Block Cover
1
Loosen the terminal block cover fixation screw(s).
2
Remove the terminal block cover from the bottom, while pressing its lower sides in the
directions of the arrows.
You can find one terminal block cover fixation screw at the lower right of the cover for inverters
with a capacity of 3.0 kW or lower, or two terminal block cover fixation screws on both sides of
the cover for inverters with a capacity of 3.7 kW or higher.
Also note that the option unit cover is screwed to the terminal block cover, but not fixed to the
inverter body. Therefore, you can remove the terminal block cover without removing the option
unit cover.
Multi-function Compact Inverter 3G3MX2-V1 User's Manual (I585-E1)
Press in the arrow
directions to remove
the terminal block
cover from the bottom.
Option unit cover
Terminal block
cover
Terminal block cover
fixation screw
(1 for 3.0 kW or lower)
Terminal block cover
fixation screw
(2 for 3.7 kW or higher)
2 Design
2
2 - 7