Setting Up The Raw Tcp Print; Setting Up The Lpd Print - imagistics cm4530 Network Administrator's Manual

•
SUPPLEMENT:
•
NOTE:

Setting up the Raw TCP Print

In Raw TCP Print, you can enable or disable the Raw TCP print service.
1
2
3

Setting up the LPD Print

In LPD Print, you can set the LPD print options to enable the LPD/LPR print service.
1
2
3
86
If you want to restore the current settings without saving the changes, click [Cancel].
Clicking [Cancel] cannot restore the defaults. This can only clear the changes and
restore the current settings before saving the changes.
5.
Click [OK] to apply the changes.
When using the Internet Explorer, the settings that are displayed in each field may
not be changed even if you change the settings and click [Save]. However, the set-
tings have been changed in the equipment. In that case, click the Print Service sub-
menu then the page displays the current settings in each field.
1) Enable Raw TCP
Enable or disable Raw TCP print service.
2) Port Number
If enabling the Raw TCP, enter the Raw TCP port number for the Raw TCP print. Generally
"9100" is used.
3) Enable Raw bi-directional
Enable or disable Raw bi-directional communication.
1) Enable LPD
Enable or disable LPD print service.
2) Port Number
If enabling the LPD, enter the LPD port number. Generally "515" is used.
3) Banners
Select whether printing a banner page for each print job using LPR printing.
Network Administrator's Guide — Setting up Print Service Settings