13
13.2
When Copying Is Not Performed Correctly
Symptom
Nothing appears on the
display.
The [START] key indicator is
not lit up in green.
Even though the [START] key
is pressed, no copies are
made.
The machine cannot be set to
Copy mode.
The machine cannot be turned
on.
13-4
Possible Cause
Only the [START] key
indicator is lit up in green.
The "AUTO SHUT OFF"
function was activated.
A user (section) ID number
has not been entered.
If the "ERROR" indicator on
the Control Panel is lit, an
error has occurred.
If the machine was just
turned on, it is still warming
up.
The machine is in Interrupt
mode (the "INTERRUPT"
indicator is lit).
The power supply cord has
been unplugged from the
electrical outlet.
The breaker for the
electrical circuit has been
tripped.
Troubleshooting
Remedy
The machine is in Power
Save mode (preheat
mode).
Press any key to cancel
Power Save mode.
(p. 3-25)
Set the Power Switch to "O"
(p. 3-28).
Enter the user (section) ID
number according to the
instructions in "To enter an
ID number" on page 3-27.
Follow the instructions in
any messages that appear
on the display.
The machine takes about
30 seconds to warm up
after it is turned on.
Press the [INTERRUPT]
key to cancel Interrupt
mode. (p. 3-26)
Plug the power supply cord
into the electrical outlet.
Close the breaker for the
electrical circuit.
Konica 7115F/7118F