When The Copier Is Not Operating Correctly - Konica Minolta DI2510 Advanced Information

13
13.3

When the Copier Is Not Operating Correctly

Symptom
Nothing appears in the touch
panel.
The indicator on the [Start] key
does not light up in green.
Even though the [Start] key is
pressed, no copies are made.
The machine cannot be set to
Copy mode.
The machine cannot be turned
on.
* If the problem is not corrected even after the operations described are performed, turn off
the copier,unplug its power supply cord, and the contact your service representative.
13-6
Possible Cause
If only the indicator on the
[Start] key is lit, the copier is
in Energy Saver mode or
Sleep mode.
The copier has not been
turned on.
The contrast control knob
for the touch panel has
been set either too light or
too dark.
Has the LCD back-light
being set to off?
An access code has not
been entered.
The copy/print job is
queued and waiting to be
printed.
The copier is still warming
up after just being turned
on.
The copier is
malfunctioning.
The copier is in Interrupt
mode (the "Interrupt"
indicator is lit).
The power supply cord has
been unplugged from the
electrical outlet.
The breaker for the
electrical circuit has been
tripped.
Troubleshooting
Remedy
Press any key in the
operation panel to cancel
Energy Saver mode.
Check that the copier's
power switch has been set
to "I" and that the sub power
switch has been pressed in.
While looking at the touch
panel, adjust the contrast
control knob.
Please press a key on the
control panel or touch
panel.
Please change the LCD
back-light off settings.
Refer to "To set the "LCD
Back-light Off" function" on
page 7-17.
Enter the access code
according to the procedure
described in "Making
Copies Using Accounts".
Touch [Job List] to check
the jobs that are queued.
Wait until printing begins.
The copier takes about 17
seconds to warm up after it
is turned on.
Wait until the copier has
finished warming up.
Follow any messages that
appear on the touch panel.
Press the [Interrupt] key to
cancel Interrupt mode.
Plug the power supply cord
into the electrical outlet.
Close the breaker for the
electrical circuit.
Di2510/Di3010/Di3510