Transfer Function - Sharp UX-51 Operation Manual

Transfer Function

The Transfer function is used to make the UX-238/51 automatically call you
at a specified number every time it receives an incoming message in a
selected box. This allows you to hear your messages immediately after they
come in, even when you are at a remote location.
When you answer the telephone, you will hear your recorded message telling
you that the call is a transfer call. Enter "#", the box number, the box's
passcode (or your remote code number if the box has no passcode), and "#".
The UX-238/51 will then play back your messages. You can also perform
any of the remote operations described in Remote Operations in this chapter.
Note: When you hang up after a transfer call, the UX-238/51 will not
immediately resume normal operation. If you want the UX-238/51 to
accept calls immediately after a transfer call, enter "*" twice before
hanging up (if you want to hang up during message playback, first enter "
0" and " #" to stop playback, then enter "*" twice).
Programming the transfer number
To use the Transfer function, you must first give the UX-238/51 the number
to call (the transfer number). This is done by pressing the panel keys as
follows:
1
Press these keys:
The display will show:
2
Press these keys:
The display will show:
FUNCTION
0
A.M. SETTINGS
TRANSFER # ENTRY
Transfer Function
33