Sharp UX-51 Operation Manual page 67

Receiving Documents
Answering with an extension phone
1
Answer the extension phone when it rings.
2
If you hear a fax tone when you answer an extension phone, wait until your
fax answers (the extension phone will go dead), and then hang up.
Beep
3
If the fax doesn't respond, or if the other party first talks to you and then
wants to send a fax, press 5, *, and * on the extension phone (only on a
tone dial phone). Hang up.
5
Comments:
Your fax will not accept the signal to begin reception (5**) if a document is
loaded in its feeder.
If you have set Option Setting 11 to NEIN and hear a fax tone when you
answer the extension phone, you must press 5, *, and * if you are on a tone
dial phone, or walk over to the fax, pick up the handset, and press the
START/MEMORY key if you are on a pulse dial only phone.
The code used to activate fax reception from a tone dial extension phone
(5**) can be changed if desired. See Option Setting 4 ("Tel/Fax Remote
Number") in Chapter 8, "Option Settings".
Paper cutting
UX-51: After receiving a document, grasp the paper by the edge and pull
upward to tear it off.
UX-238: After receiving a document, your fax will automatically cut each
page to a length slightly longer than the original pages.
66
Phone goes
dead