Sharp UX-51 Operation Manual page 33

Optional Answering Machine Settings
Fax reception on A.M. failure
If the memory for recording incoming messages becomes full while you are
out, the answering machine will no longer be able to record messages. The
ON A.M. FAILURE setting is used to choose the response of the machine to
incoming calls when this happens:
Automatic fax reception NO: The UX-238/51 will answer after 20 rings,
after which it will wait to receive a remote command. Most callers will
hang up before it answers; however, when you call the UX-238/51 from
a remote location, you can wait until it answers, listen to your messages,
and then erase them (see Remote Operations in this chapter).
Automatic fax reception YES: The reception mode will switch to FAX
mode, allowing the UX-238/51 to continue to receive faxes
automatically without broadcasting an OGM on answering. With this
setting, you can still use the remote commands to listen to your
messages and erase the message memory (see Remote Operations in this
chapter).
Automatic fax reception is set to NO at the factory before shipping. If you
want to set it to YES, press the panel keys as follows:
1
Press these keys:
The display will show:
2
Press these keys:
The display will show:
3
Press 1 to turn automatic fax reception on,
or 2 to turn it off.
4
Press the STOP key.
32
FUNCTION
0
A.M. SETTINGS
ON A.M. FAILURE
1 or 2
STOP