Transfer Function - Sharp UX-485 Operation Manual

Transfer Function

Transfer Function
The Transfer function is used to make the UX-485 automatically call you at a
specified number every time it receives an incoming message. This lets you hear
your messages immediately after they come in, even when you are at a remote
location.
When you answer the telephone, you will hear your recorded message telling you
that the call is a transfer call. Enter "#", your remote code number, and "#". The
answering machine will then play back your messages. You can also perform any of
the remote operations described in the previous section.
Note: When you hang up after a transfer call, the UX-485 will not immediately
resume normal operation. If you want the UX-485 to accept calls immediately after a
transfer call, enter "*" twice before hanging up (if you want to hang up during
message playback, first enter "0" and " #" to stop playback, then enter "*" twice).
Programming the transfer
number
To use the Transfer function, you
must first give the UX-485 the number
to call (the transfer number). This is
done by pressing the panel keys as
follows:
1
Press these keys:
FUNCTION
TRANSFER # ENTRY
2
Press the START/MEMORY key.
START/MEMORY
32
0
Press 6
times
3
Enter a transfer number (max. of 32
digits including pauses) by pressing
the number keys.
ABC
1
JKL
GHI
4
PQRS TUV
7
4
Press the START/MEMORY key
and then the STOP key.
START/MEMORY
DEF
2 3
MNO
6
5
WXYZ
9
8
STOP