Sharp UX-51 Operation Manual page 43

Remote Operations
5
When you have finished listening to your
messages, you can do any of the
following:
Erase all messages: To erase all of the
messages in the box, press "3", "3",
and "#".
Repeat playback: To listen to your
messages again, press "7" and "#".
Perform other operations: You can
enter any of the commands described in
the following section, "Other remote
operations".
Hang up: If you do not erase your
messages first, they will be saved and
any new messages will be recorded
after them. If you want the UX-238/51
to resume normal operation
immediately, press "*" twice before
hanging up (in some cases, particularly
when the Transfer function is used, the
UX-238/51 may not accept new calls
for one or two minutes after you hang
up unless you first press "*" twice).
Comments:
When a remote command is accepted by the machine, you will hear one
beep. If an incorrect command is entered, you will hear four beeps. In the
latter case, re-enter the correct command.
When entering a command, do not pause longer than 10 seconds between
each digit. If you do, a 4-beep error signal will be issued and the digits
entered up to that point will be disregarded. In this case, re-enter the
command from the beginning.
If you make two errors (causing two 4-beep signals to be issued) while
entering your remote code number, the line will be disconnected. This
prevents unauthorized people from attempting to guess your remote code
number.
If you pause for longer than 60 seconds before entering a command, you will
be disconnected.
42
3 3
7