Configuring The Number Of Geqs (And Effects) - Midas PRO SERIES Owner's Manual

Configuring the number of GEQs (and effects)

Item
5
6
7
8
9
10
11
Configuring the number of GEQs (and effects)
GEQ (and effects) configuration is a GUI-only operation. We recommend that you
configure the number of GEQs and effects before you start using the PRO Series.
>> To configure the PRO Series Control Centre with the number of GEQs and
effects
1
At the GUI, choose home
2
In the Effects and GEQs section of the
Configuration Preferences option, open the
drop-down list (as shown right).
3
Select the option you want by clicking it. For example,
click the 3 Effects - 28 GEQs option (PRO6 or PRO9
only) to have three internal effects and 28 GEQs.
PRO Series Live Audio Systems
Owner's Manual
Control
EQ button
10-segment meter
Q button
Notch filter control
knob
IN button
Notch filter control
knob
Fader group ID
number
Function
Selects the EQ. The adjacent green IN LED shows
the EQ is on (illuminated) or is being bypassed
(extinguished).
Shows the incoming signal level and is pre-EQ (but
post-gain control). Clipping is post-EQ (and post-
gain control), such that internal clipping due to
excessive EQ, that is, if a high input level is further
boosted by the use of EQ, will also be shown. The
LED functions are: two red LEDs illuminate when
signal has exceeded +20dBu and is being clipped;
two yellow LEDs illuminate when signal level exceeds
0dB (range is between 0dB to +20dB); and the top
five green LEDs encompass the signal level range of
between 0dB and -40dB, while the bottom one
illuminates when the signal has exceeded -40dB.
Selects proportional Q (PROP.) or constant Q (CON.)
modes.
Adjusts the position of the notch filter within the
range 20Hz to 20kHz.
Switches the respective high pass/low pass/notch
filter in/out.
Adjusts the position of the notch filter within the
range 200Hz to 2kHz.
See "Controlling a GEQ via the I zone" on page 194.
Preferences General.
161