Changing The User Interface Preferences; Changing The Signal Processing Preferences - Midas PRO SERIES Owner's Manual

250

Changing the user interface preferences

The User Interface Preferences section of the
Preferences screen lets you set some of the PRO Series
Control Centre's operating parameters to suit your own
preferences.
• Display Rotary Values — the current value of a control
knob can be displayed as a numerical value on the GUI
(see "Parameter values displayed on touch" on page 54).
• Fast Zone Delay Control — selecting this option means
that you place the delay control for the inputs onto the
surface controls. To do this you have to cycle the gain
swap switch (see "Mic amp input gain (preliminary input
processing)" on page 286) through digital gain, analogue
gain and then delay. Without selecting this option, the inputs delay control is a GUI
only feature.
• Select follow Solo — when you solo an aux or matrix output, the channel is
automatically selected, thus bringing the output controls to the surface detail area.
This option only works in fader flip mode.
• Automate Paging — select this option to store channel paging in automation. So
that, on scene recall, the control surface (channels assigned to it) will revert to the
state it was in when the scene was last saved. When unselected, scene recall does
not affect channel paging.
• Overwrite Safed parameters — see "Overriding store scope" on page 207.
• Fader flip:
• Choose between Flip to faders and Flip to Pans to control the currently
selected mix bus using the faders or the pan control buttons, respectively, in the
full input bay (see "Controlling the mix buses in flip mode" on page 48).
• Sync Area B — when the PRO Series Control Centre is set up for two-man
operation (see "Two-man operation" on page 122) and you are using fader flip,
selecting this option will synchronise the mix bus selection across areas A and B,
so that both areas operate on the same mix buses.
• VCA Unfolding — select Overlay Stereo Pairs to unfold only left channels of
channel pairs when a VCA group is selected; use the scroll by 1 navigation buttons
to display any right channel you want.
• Names Lists — click the SET NAMES to open a window from which you can change
the names in the input and output sheet lists (see "Changing the default input/
output names" on page 251).

Changing the signal processing preferences

The Signal Processing Preferences section of the
Preferences screen lets you set up your DSP preferences.
• DSP Timeout — control knob for adjusting the amount of
time (between 10 and 600 seconds) the DSP engine will
continue to run after an update is received from the
control surface, before muting the audio.
• inf — tick box for selecting infinity, which will allow audio to continue indefinitely if
power to the control surface is lost.
• Master to Matrix Post-processing — tick box for selecting whether the tap-off
point is either a pre- or post-master channel processed signal that is sent to the
matrix channels (see "Master to matrix post-processing option" on page 257), and
determines whether the signal is sent without or with processing, respectively. This
Chapter 27: Changing The User Settings
PRO Series Live Audio Systems
Owner's Manual