Solo system
>> To activate SIP
1
Do one of the following:
• On the control surface, lift up the cover of the solo in place button and then
• At the GUI, choose home
2
In the "Activate SIP ?" message window, click OK.
>> To deactivate SIP
Press/click the solo in place button (control surface or GUI).
C/O switch
The C/O (a/b speaker) switch (control surface only) swaps
speakers A with speakers B. The button's LED illuminates when the B
set of speakers are on.
Monitor output (a and b) sections
The monitor output sections — output a and
output b — have common controls for the monitor A
and B sections. The monitor's output level is
controlled by a non-automated fader, a DIM switch
and left and right mutes (see Figure 20 "Monitor A
and B strips" on page 144).
The buttons in each output section have an integral
LED for on/off indication, and have the following
functions:
• MONO/[MON] switch, sums left and right signals,
but with a ±3dB loss. With 0dB on monitor A left
and nothing on monitor A right, pressing MONO
gives -3dB on both monitor A left and monitor A right. However, with 0dB on both
monitor A left and monitor A right, pressing MONO gives +3dB on them both.
• ø/[PHS] phase reverse switch, reverses the phase of the right monitor signals.
• LEFT/[LFT] and RIGHT/[RGT] switches, route left and right monitor signals,
respectively, to both left and right monitor speaker outputs. These switches can be
used in combination, as shown in Table 11 below.
Table 11: Monitor signal routing
LEFT
button
Off
On
Off
On
PRO Series Live Audio Systems
Owner's Manual
press the button.
RIGHT
button
Monitor signal routing
Off
Left and right monitor signals are routed normally, that is,
left monitor signal is routed to the left monitor speaker
output, and the right one is routed to the right monitor
speaker output.
Off
Left monitor signal is routed to both of the monitor speaker
outputs.
On
Right monitor signal is routed to both of the monitor
speaker outputs.
On
Left and right monitor signal routing is swapped over, that
is, left monitor signal is routed to the right monitor speaker
output, and the right one is routed to the left monitor
speaker output.
Monitors. Then click solo in place.
147