Solo Mode Section (Gui Only); Solo System Section - Midas PRO SERIES Owner's Manual

Solo system

solo mode section (GUI only)

On the GUI, the solo mode section has a select
button by which you can cycle through the solo
mode options to select the one you want. Each
option has an LED that illuminates when its option
is selected.
The options are as follows:
• normal — both solo systems (A and B), are
active and behave as a single solo system.
• dual op. — in dual operator mode, both solo systems (A and B) are totally
independent of each other. The solo B button, in addition to routing the soloed
material to monitoring system B, determines which set of PFL, ADD and CLEAR
controls (see "solo (a and b) sections" on page 148) are applied to the solo.
• lcr mon. — left-centre-right monitor mode is similar to normal mode, but when
nothing is being soloed the left and right masters are routed to the monitor A output
and the mono master is routed to the monitor B output.
Pressing any solo switch on the control centre temporarily overrides the selected
primary source selection, while the talk assignment is unaffected (this signal is
summed further down the signal path, so as not to affect the monitor meters).
Each mode changes interleaving logic between different areas of monitor output.
• broadcast — routes stereo masters to the monitor A output and activates all the
solo B controls so that soloed material is routed to the monitor B outputs. This
allows the master outputs to be continually broadcast (probably the on-air
program), while the other material is soloed.
• user def. — in user-defined mode, you can set up the monitoring system. These
settings are recalled on return to this mode after using one of the other solo modes,
for example, normal mode or broadcast mode. (User defined monitor settings are
not stored in scenes or show files.)
• surround — all levels are controlled from the channel A fader.

solo system section

The solo system section has three control knobs,
as follows:
• pfl level control knob — PFL audio bus may
accept injected external signals. This control
knob adjusts the pre-fader level in the range
infinity (∞) to +10dB.
• afl level control knob — AFL audio bus may
accept injected external signals. This control
knob adjusts the after-fader level in the range
infinity (∞) to +10dB.
• talk back control knob — adjusts the talk back level, in the range infinity (∞) to
+10dB.
PRO Series Live Audio Systems
Owner's Manual
149