Using Patching In Automation; Using Zoom - Midas PRO SERIES Owner's Manual

208
>> To override the safed parameters (selected in store scope) for every scene
At a GUI screen, choose home
screen, and select the Overwrite Safed parameters option (see "Changing the user
interface preferences" on page 250) in the User Interfaces Preferences section.

Using patching in automation

You can change the patching of certain sources and destinations on a per-scene basis.
For example, you have an input channel's compressor side chain patched from one
source in one scene and from a different source in another scene.
For details of the parameters that can be patched per scene, see Appendix L
"Parameters Affected By Automate Patching".
>> To use patching in automation
At a GUI screen, choose home
screen, and then select the Automate Patching option in the Configuration
Preferences section.

Using zoom

You can enlarge the cue list to zoom in on certain scenes or make
the scenes in the cue list smaller so that you can view more scenes
simultaneously. This is done using the Zoom List spin buttons.
>> To enlarge the scene view (zoom in)
In the Automation screen, click the up (top) Zoom List
spin button. The diagram right shows a typical
Automation screen at maximum zoom.
>> To reduce the scene view (zoom out)
In the Automation screen, click the down (bottom)
Zoom List spin button. The diagram right shows a typical
Automation screen at minimum zoom.
Chapter 20: Scenes And Shows (Automation)
Preferences
Caution:
The Automate Patching option switches on per-scene automatic
routing, and must be used with caution. To alert you to the drastic
consequences of using this option, a WARNING window appears.
Preferences
General to open the Preferences
General to open the Preferences
PRO Series Live Audio Systems
Owner's Manual