Step C - Configuring The Firewire Settings For The Venicef - Midas Venice F32 Operator's Manual

22
8
After the wizard has finished installing
the driver, click Finish.
After the device hardware has been
successfully installed, you will see a Found
New Hardware balloon on your desktop.
You are now ready to configure the VeniceF FireWire settings (see Step C below).
Step C — Configuring the FireWire settings for the VeniceF
In general, you should be able to use your recording software application on your
PC/Mac quite successfully using the default FireWire settings. However, you can
change the settings, if desired (for example, if you have audio problems), which is done
in the Midas FW FireWire settings window.
Configuration of the VeniceF's FireWire settings involves opening the Midas FW
settings window, selecting your desired options and then closing the window.
>> To open the Midas FW settings window
1
On your PC/Mac desktop, double-click
the Midas FW icon.
2
If no devices are found, you will see
the message shown right. Make sure
the PC/Mac and console are properly
connected together with the FireWire
cable, and then click ok.
3
The Midas FW settings window will
open. In the Devices section you
should see the Venice icon (shown
right).
Chapter 3: Using The VeniceF With FireWire
VeniceF
Operator Manual