Swapping The Active Network; Swapping The Active Master Controller - Midas PRO SERIES Owner's Manual

396

Swapping the active network

In the highly unlikely event that the active network (X or Y) develops a malfunction,
you can swap over to the standby network, making this the active one.
Note: The swap function does not swap control data, as this non-audio data finds its
own way through the network. This allows the router to swap to the inactive link, even
if the active link is broken or removed.
>> To check the health of the active network
At the GUI, open the Diagnostics screen by choosing home
check the status of the active HyperMac link. If it is green the link is good, but if it is
red there is a problem and you should swap to the standby HyperMac link.
>> To swap the networks
1
At the GUI, open the Diagnostics screen by choosing home
2
Click SWAP HYPERMAC.
3
In the prompt window (shown
right), click OK. The active
and standby networks will
swap over.

Swapping the active master controller

Although it is highly unlikely that the active master controller (MC) will develop a
malfunction, should it ever happen you will need to activate the standby MC.
>> To swap the active master controller
1
At the GUI, choose home
2
Click FILE SYNC.
3
In the Master Controller File Synchronisation window, click the MAKE
ACTIVE button of the standby MC (shown below). This will become the active
one.
Appendix G: Troubleshooting
Files.
Diagnostics, and then
Diagnostics.
PRO Series Live Audio Systems
Owner's Manual