Interrupting Weekly Timer Mode - Konica Minolta Di5510 Advanced Information

3

Interrupting Weekly Timer Mode

The weekly timer is enabled if the LED of the TIMER display on the control
panel is lit. Interrupt the weekly timer mode to make copies.
1
Press the [Energy Saver] key on the control panel.
A message is displayed on the
touch screen.
? Does the message prompt you
to enter a code?
The weekly timer is protected with a 4-digit weekly timer code.
§
Enter the correct code. Confirm your input by pressing [Start].
2
Use the 10-Key Pad to enter the
number of hours (0-9) by which the
weekly timer should be delayed.
3
Confirm your input by pressing [Start].
4
Use the 10-Key Pad to enter the
number of minutes (00-59) by which
the weekly timer should be delayed.
5
Confirm your input by pressing [Start].
The system is ready for operation.
Protecting the weekly timer with a code
You can specify a 4-digit code for protecting the weekly timer. For
more information, see page 7-46.
3-4
Initial Steps . . .
Input copy time
0 hour(s) 05 minute(s)
Input copy time
8 hour(s) 05 minute(s)
Input copy time
8 hour(s) 07 minute(s)
Position original in the EDH
face up
Di5510/Di7210