Table of Contents
Advertisement
Basic Functions
5
Under "Size" select the size of the paper you have loaded.
?
Did you select "STD size (special)"?
§
Use the arrow keys to select the desired size.
?
Did you select "Non STD size"?
§
First select length or width. Then specify the desired dimension
using the touch screen keypad or the arrow keys.
?
Did you select "Wide size paper"?
§
Set the copy start. For more information, see page 4-64.
§
Use the arrow keys to select the desired size from the list.
or
§
Press the [Input size] key. The display on the touch screen
changes. First select length or width. Then specify the desired
dimension using the touch screen keypad or the arrow keys.
6
Press the [OK] key to confirm your input.
The basic options are displayed again.
7
Configure the system settings for your job.
8
Press the [Start] key on the control panel to start the copy job.
When selecting "A5, thick" do the setup on the system!
If you wish to use thick paper in A5
format, the lever on the transport
unit on the copier must be set as
shown in the diagram.
Do not forget to slide the lever back
to its original position after the copy
cycle.
Di5510/Di7210
4
4-63
Advertisement
Table of Contents
