Cam Era Hardware Interface; Installation Overview; Input/Output Connectors And Led - Dalsa Stop Action 4M30 User Manual

4M Stop Action Camera Manual
Camer
Interface
2.1 In allation Overview st
When setting up your camera, y
1.
This installation
overview assumes you
2.
have not installed any
system components yet.
3.
4.
5.
6.
7.
8.
You must also set up the other components of your system, including light sources,
camera mounts, computers, optics, encoders, and so on.

2.2 Input/Output Connectors and LED

The camera uses:
•
•
DALSA
PRELIMINARY
a Hardware
Power down all equipment.
Following the manufacturer's instructions, install the frame grab
sure to observe all static preca
Install any necessary imaging software.
Before connecting power to the camera, test all power supplies.
Inspect all cables and connectors prior to installation. Do not use
connectors or the camera may be damaged.
Connect Camera Link and power cab
After connecting cables, apply power to the c
Check the diagnostic LED. If camera is operating correctly, the LED will flash for 30
secon ds and then turn solid green. See 2.2.1 LED Status Indicator for a description of
LED states.
A diagnostic LED for monitoring the camera. See LED Status Indicator in section 2.2.1
LED Status Indicator for details.
Two high-density 26-pin MDR26 connectors for Camera Link control signals, data
signals, and serial communications. Refer to section 2.2.2 Camera Link Data
Connector for details.
ou should take these steps:
utions.
les.
amera.
11
2
ber (if applicable). Be
damaged cables or
03-32-10121-09