Dalsa Stop Action 4M30 User Manual page 14

14
23
11
24
12
25
13
26
Notes:
*Exterior Overshield is connected to the shells of the connectors o
**3M part 14X26-SZLB-XXX-0LC is a complete cable ass
Unused pairs should be terminated in 100
Inner shield is connected to sign
Table 6: DALSA Camera Control Configuration
CC1
CC2
CC3
CC4
Input Signals, Camera Link
The camera accepts control inputs through the Camera Link MDR26F connector.
T he camera ships in internal sync, internal programmed integration (exposure mode 2), and Camera Link mode
16 (4M60)
EXSYNC
Frame rate can be programmed using t
IMPORTANT:
EXSYNC is optional and enabled th
Camera reado ut is
edge of EXSYNC to trigger frame readout. Section details how to set fr
t riggered on t he falli ng
edge of EXSYNC. exposure times, and camera modes.
Output Signals, Camera Link
These signals indicate when data is valid, allo
to you
you should refer to the DALSA Camera Link Implementation Road Map, available at
http://vfm.dalsa.com/, for the standard location of these signals.
LVAL (high)
DVAL (high)
STROBE (rising edge)
FVAL (high)
03-32-10121-09
PRELIMINARY
4
16
3
15
2
13
26
al ground inside camera
EXSYNC
Reserved for future use
Reserved for future use
Window toggle
or 3 (4M30).
r acquisitio n system. These signals are part of the Camera Link configuration and
Outputting valid line
Valid data
Valid data
Outputting valid frame
Z 2+ 23
Zclk- 11
Z clk+ 24
Z3- 12
Z 3+ 25
inner shield 13
inner shield 26
n both ends.
embly, including connectors.
ohms at both ends of the cable.
he serial interface. The external control signa
rough the serial interface. This camera uses the falling
wing you to clock the data from the camera
4M Stop Action Camera Manual
4 CC2-
16 CC3-
3 CC3+
15 CC4+
2 CC4-
13 inner shield
26 inner shield
l
ame times,
DALSA