Camera Hardware Interface; Installation Overview - Dalsa Piranha HS 4x-02K30 User Manual

Piranha HS 4x User's Manual
Camera Hardware
Interface

2.1 Installation Overview

When setting up your camera, you should take these steps:
1.
This installation
overview assumes you
2.
have not installed any
system components yet.
3.
4.
6.
7.
8.
9.
You must also set up the other components of your system, including light sources,
camera mounts, host computers, optics, encoders, and so on.
DALSA Corp.
Power down all equipment.
Following the manufacturer's instructions, install the framegrabber (if applicable). Be
sure to observe all static precautions.
Install any necessary imaging software.
Before connecting power to the camera, test all power supplies. Ensure that all the
correct voltages are present at the camera end of the power. Power supplies must
meet the requirements defined in section 2.4.
Inspect all cables and connectors prior to installation. Do not use damaged cables or
connectors or the camera may be damaged.
Connect Camera Link and power cables.
After connecting cables, apply power to the camera.
Check the diagnostic LED.
PRELIMINARY
11
2
03-32-10040-03