Table of Contents
Advertisement
10
2. Camera Hardware Interface
Installation Overview
When installing your camera, you should take these steps:
1. Power down all equipment.
This installation
2. Follow the manufacturer's instructions to install the frame grabber (if
overview assumes you
have not installed any
system components yet.
3. Install any necessary imaging software.
4. Before connecting power to the camera, test all power supplies. Ensure that all
5. Inspect all cables and connectors prior to installation. Do not use damaged cables
6. Connect Camera Link and power cables.
7. After connecting cables, apply power to the camera.
8. Check the diagnostic LED. See the
You must also set up the other components of your system, including light sources, camera mounts, host
computers, optics, encoders, and so on.
Input / Output Connectors and LED
The camera uses:
A diagnostic LED for monitoring the camera.
•
High-density 26-pin MDR26 connectors for Camera Link control signals, data signals, and serial
•
communications. Refer to the
One 6-pin Hirose connector for power. Refer to the
•
03-032-20135-00
applicable). Be sure to observe all static precautions.
the correct voltages are present at the camera end of the power cable. Power
supplies must meet the requirements defined in the
or connectors or the camera may be damaged.
description.
Camera Link Data Connector
Power Connector
LED Status Indicator
section for details.
Power Connector
section for details.
Piranha HN RoHS User Manual
section.
section for an LED
Teledyne DALSA
Hide quick links:
Advertisement
Table of Contents
