Table of Contents
Advertisement
1M28 and 1M75 User's Manual
Camera Hardware
Camera Hardware
Camera Hardware
Camera Hardware
Interface
Interface
Interface
Interface
2.1 Configuration
The different modes of operation and settings are programmed in the camera by an
asynchronous serial communications available through the Camera Link interface. The
serial interface operates at 9600 baud. The default values are stored in an EEPROM, which
is automatically read at power up. The user can change the factory settings of the default
values in the EEPROM to configure the camera to the requirements of their own
application. You can also save the set of default values to a file over the asynchronous
serial communications interface, or restore default settings saved in a file to the EEPROM.
The configuration is most easily done with the PFRemote configuration tool shipped with
the camera. The PFRemote tool is explained in section 3.2 PFRemote Configuration Tool
on page 30.
2.2 Installation Overview
In order to set up your camera, you should take these steps:
1. Connect Camera Link™ cables from camera to framegrabber.
2. Connect power.
You must also set up the other components of your system, including light sources,
framegrabbers, camera mounts, heat sinks, host computers, optics, encoders, and so on.
See section 2.1 above for camera configuration information.
DALSA
PRELIMINARY
19
2
03-32-00525-03
Advertisement
Table of Contents
