Camera Hardware Interface; Installation Overview; Input/Output - Dalsa P-2 Series User Manual

13
Camera Hardware
Interface

2.1 Installation Overview

In order to set up your camera, you should take these steps:
1. Connect Camera Link™ cables from camera to framegrabber.
2. Connect power.
You must also set up the other components of your system, including light sources, frame
grabbers, camera mounts, heat sinks, host computers, optics, encoders, and so on.

2.2 Input/Output

WARNING: It is extremely important that you apply the appropriate voltages to your
!
camera. Incorrect voltages will damage the camera. See section 2.4 for more details.
03-32-00493-11
Camera Link™ (2 and 4Tap models)
Camera Link™ (4Tap model only)
Diagnostic LED (S ee section 3.18)
+12V to +15V and Ground
Piranha2 User's Manual
2
DALSA