4M Stop Action Camera Manual
Troubleshooting
The information in this chapter c
setup of your camera. Rem
You m
Your steps in dealing
1.
2.
5.1 Common Solutions
Con
nections
The first step in troubleshooting is to verify th
connections.
Power Supply Voltages
Check for the presence of all voltages at the camera power connector. Verify the
connector pinout and that all grounds are connected. Refer to section 2.2.3 Power
Connector for details.
Note:
Data Clocking/Output Signals
To validate cable integrity, have the camera send out a test pattern and verify it is being
properly received. Refer to section 3.8 for further information on running test patterns.
DALSA
PRELIMINARY
ember
ay have to troubleshoot any or all of the following:
power suppli
es
frame grabber hardware &
software
light sources
operating environment
with a technical problem should be:
Try the general and specific solutio
If these solutions do not
support.
Avoid hot plugging long power cables into the camera.
an help
you solve problems that may occur during the
that the cam
era is part of the entire acquisition system.
cabling
host computer
optics
encoder
ns listed in sections 5.1, 5.2 and 5.3.
resolve your problem, see section 5.4 on getting product
at your camera has all the correct
51
5
03-32-10121-09