Camera Hardware Interface; Installation Overview; Input/Output Connectors And Led - Dalsa Piranha HS Series User Manual

Piranha HS-xx RoHS User Manual
Camera Hardware
Interface

2.1 Installation Overview

When installing you r cam era, you shou ld take these steps:
This installation
1.
overview assumes you
2.
have not installed any
system components yet.
3.
4.
5.
6.
7.
8.
You m u st also set u p the other com ponents of you r system , inclu d ing light sou rces,
cam era m ou nts, host com pu ters, optics, encod ers, and so on.

2.2 Input/Output Connectors and LED

The cam era u ses:

Teledyne DALSA
All manuals and user guides at all-guides.com
Pow er d ow n all equ ipm ent.
Follow the m anu factu rer's instru ctions to install the fram egrabber (if applicable). Be
su re to observe all static precau tions.
Install any necessary im aging softw are.
Before connecting pow er to the cam era, test all pow er su pplies. Ensu re that all the
correct voltages are present at the cam era end of the pow er cable. Pow er su pplies
m u st m eet the requ irem ents d efined in section 2.2.2 Pow er Connector.
Inspect all cables and connectors prior to installation. Do not u se d am aged cables or
connectors or the cam era m ay be d am aged .
Connect Cam era Link and pow er cables.
After connecting cables, apply pow er to the cam era.
Check the d iagnostic LED. See 2.2.1 LED Statu s Ind icator for an LED d escription.
A d iagnostic LED for m onitoring the cam era. See LED Statu s Ind icato r in section 2.2.1
LED Statu s Ind icator for d etails.
17
2
03-032-20013-03