Dalsa Stop Action 4M30 User Manual page 61

4M Stop Action Camera Manual
set analog offset
set baud rate
set exposure mode
set exposure tim
set sync frequency
set system gain
set video mode
DALSA
PRELIMINARY
sao t i
sbr m
sem m
e
set f
ssf f
ssg t i
svm m
Set the analog gain .
t = Tap selectio n. Allowable value is 0
for all taps.
i = An alog offset value. Allowable
range is 0 - 1023 .
Set the speed of the serial
communicatio n port. Baud rates: 9600 ,
19200 57600 , and 115200 . Default ,
baud: 9600
Set the exposure m ode. Available
values are:
2 : Internal SYNC, programmable frame
rate and exp osure time using
commands and set. Exposure
ssf
control enable d (ECE).
3 : External SY NC, maximum exposure
time, exposure control disabled
(ECD )
4 : Smart EXSYN C. Exposure control
enabled (ECE).
7 : Internal program mable SYNC,
m ximum expos a ure time, exposure
control disab led (ECD)
Sets the exposure time to a floating
point number in µs. Allowable range is
10 - 999989 µs in increments described
in Table 11: Allowable Exposure Time
Increments on page 27.
Sets the frame r ate in Hz to a value
from 1 to 62.1 (4M60 full frame) or 1
to 31 (4M30 half frame).
Sets the digital gain.
t = Ta se p lec tion. Allowable value is 0
for all tap s.
i = Ga in val ue is specified from 0 to
65535 . Th e digital video values ar
multiplied by this number.
Se ts the camera's video mode.
0 : V ideo mode
1: Test pattern checkerboard
: Test pattern alternating line 1
2
3 : Test pattern alternating line 2
4 : Test pattern horizontal ramp
5 : Test pattern vertical ramp
6: Test pattern diagonal ramp
7: Test pattern FPN
8: Test pattern PRNU
9: Test pattern fixed 1023
10: Test pattern fixed 255
61
e
03-32-10121-09